Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Battery Current Sensor (2) - Install
Install the battery negative cable terminal cover (1).
Courtesy of GENERAL MOTORS COMPANY

Battery Negative Cable Clip (1) - Install [2x]
Battery Current Sensor Connector (2) - Connect
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Install body extension current sensor wiring harness to battery negative cable bolt (1) and tighten to 9N.m (80 lb in).
Courtesy of GENERAL MOTORS COMPANY

Connect the battery negative pole clamp (1).
Tighten the battery negative pole clamp nut (2) to 4.5N.m (40 lb in).
Battery Negative Cable Disconnection and Connection - Connect
Fold the rear seat back cushion in original position.
Close the right rear door.
Rear Compartment Floor Panel Trim Support Replacement - Remove
Rear Compartment Floor Panel Trim Replacement (Notchback)Rear Compartment Floor Panel Trim Replacement (Hatchback) - Remove
Close the rear compartment lid.
Ignition - On / Vehicle - In Service Mode & Engine - Off
Program the volatile memory. Volatile Memory Programming
Program all of the customer's radio station presets and set the radio clock to the current time.