Installation Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.

Human Machine Interface Control Module Bracket (1) - Install
CAUTION:
Refer to Fastener Caution .

Human Machine Interface Control Module Bracket Bolt (1) @ Human Machine Interface Control Module Bracket (2) - Install and tighten 2.5 N.m (22 lb in)
Human Machine Interface Control Module Bracket Bolt (1) @ Human Machine Interface Control Module Bracket (2) - Install and tighten 2.5 N.m (22 lb in)
Connect the electrical connector.
Instrument Panel Compartment (2) - Install
Connect the electrical connector.
Install the 5 instrument panel compartment bolt (1) and tighten to 2.5 N.m (22 lb in).
Instrument Panel Outer Trim Cover - Right Side (2) - Install
Instrument Panel Lower Airbag - Passenger Side (2) - Install
Connect the electrical connector.
Instrument Panel Lower Airbag Nut (1) - Install and tighten 9 N.m (80 lb in)
Instrument Panel Lower Trim Panel Insulator (3) - Install
Instrument Panel Lower Trim Panel Insulator Retainer (2) - Install [4x]
Instrument Panel Lower Trim Panel Insulator Bolt (1) - Install and tighten 2.5 N.m (22 lb in)
Install the left and right instrument panel fuse block access cover frame (1).
Install the left and right front floor console extension panel (3).
Front Floor Console Extension Panel Retainer (2) - Install [5x]
Front Floor Console Extension Panel Fastener (1) - Install and tighten 2.5 N.m (22 lb in)
Instrument Panel Fuse Block Access Hole Cover (1) - Install