LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2021 >> Tahoe SSV >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System And Washer System >> Repair Instructions >> Windshield Wiper System Module Shield Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

  1. Using the appropriate trim tool, remove both windshield wiper arm finish caps (1) from the windshield wiper arms (3).
    GM5522078Courtesy of GENERAL MOTORS COMPANY
  2. Windshield Wiper Arm Nut (2) - Remove [2x]
  3. Use the J - 39822  Wiper Arm Puller to remove the wiper arms (3) from the wiper motor pivot shaft.
  4. Apply two layers of masking tape to the painted surface around the top edge of the air inlet grille panel extensions (1) to prevent paint damage.
    GM5523134Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Quantity of retainers may vary based on option content.

  5. Using a suitable plastic trim tool, carefully release the air inlet grille panel extension clips.
  6. Air Inlet Grille Panel Extension (1) - Remove [2x]
  7. Hood Rear Outer Air Inlet Seal Retainer (1) - Remove [2x]
    GM5532143Courtesy of GENERAL MOTORS COMPANY
  8. Hood Rear Outer Air Inlet Seal (2) - Remove [2x]
  9. Air Inlet Grille Panel Retainer (1) - Remove [8x]
    GM5531724Courtesy of GENERAL MOTORS COMPANY
  10. Windshield Washer Nozzle Hose - Disconnect [3x]
  11. Lift the front edge of the air inlet grille panel (2) and slide the panel forward from both hood hinges to remove.
  12. Windshield Wiper System Module Shield (1) - Remove
    GM5537718Courtesy of GENERAL MOTORS COMPANY
scientia non olet · About LEMON Manuals