Remove & Install or Remove & Replace
WARNING: This page is about the Traverse High Country, 4WD, which is a different variant/trim than selected.
TRANSAXLE TYPE
NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 4WD, Both | 2.0 | B | ||
| 4WD, One Side | 1.1 | B | ||
| Combination Procedure: AUTOMATIC TRANSMISSION FLUID: Check: Includes: Check Fluid level and condition. | ||||
| Level,Hot Check Procedure | Includes: Confirm Fluid temperature for level check. | 0.3 | C | |
| Combination Procedure: AXLE SHAFT: Replace: NOTE: For Independent Suspension Type Axles, this operation consists of dissassembly and reassembly of the Axle Shaft Assembly and replacement of the Axle Shaft. | ||||
| Each | 1.0 | B | ||
| Combination Procedure: AXLE SHAFT BOOT: Remove & Replace: | ||||
| Inner &/or Outer,Each Side | 1.0 | B | ||
| Combination Procedure: AXLE SHAFT JOINT: Remove & Replace: | ||||
| Each | 0.5 | B | ||
| Combination Procedure: TRANSAXLE OUTPUT SEAL: Remove & Replace: | ||||
| 4WD, Left Side | 0.2 | B | ||