Installation Procedure

WARNING: This page is about a different car, the 2020 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Communication Interface Module (1) - Install
Secure the retaining tabs.
Connect the electrical connectors.
Perform the necessary programming and setup procedure:Control Module References
Courtesy of GENERAL MOTORS COMPANY

Rear Compartment Side Trim-Right Side (2) - Install
Rear Compartment Side Trim Insulator Retainer (1) - Install [ 3x ]
Courtesy of GENERAL MOTORS COMPANY

Rear End Trim Finish Panel (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Rear End Trim Finish Panel Opening Cover (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Rear Compartment Floor Panel Trim (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Cargo Tie Down Loop (3) - Install [ 2x ]

CAUTION:

Refer to Fastener Caution .

Cargo Tie Down Loop Bolt (2) - Install and tighten [ 2x ] - Fastener Specifications
Cargo Tie Down Loop Bolt Cap (1) - Install [ 2x ]