LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2023 >> Bolt EV >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Programming And Setup - All Systems) >> Repair Instructions >> K71 Transmission Control Module: Programming and Setup (8L90 (M5U)) >> Programming an Existing or New Control Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Programming an Existing or New Control Module

WARNING: This page is about a different car, the 2023 GMC Savana 3500, 2023 GMC Savana 2500, 2023 Chevrolet Express 3500, and 2023 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.

To program an existing or new control module, perform the following procedure:

  1. Install the special tool: EL-49642 SPS Programming Support Tool
  2. Ignition - On/Vehicle - In Service Mode
  3. Perform one of the following SPS Programming functions:
    NOTE:

    If both controller options below are listed, select K20/K71 Engine and Transmission Control Modules.

    • K20/K71 Engine and Transmission Control Modules and follow the on-screen instructions.
    • K71 Transmission Control Module and follow on-screen instructions.
    1. Select - Programming
    2. Select - MCVM Operations - If applicable
    3. Ignition/Vehicle - Off - For greater than 2 min
    4. Select - Setup - Follow the on-screen instructions.
  4. Clear DTCs after programming is complete. Clearing powertrain DTCs will set the Inspection/Maintenance (I/M) system status indicators to No.
  5. All OK.
scientia non olet · About LEMON Manuals