Removal Procedure

Disable the SIR system. SIR Disabling and Enabling
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Rear Side Door Sill Garnish Molding (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Quarter Upper Trim Panel Bolt Cap (1) - Remove
Quarter Upper Trim Panel Bolt (2) - Remove
Quarter Upper Trim Panel (3) - Reposition
Courtesy of GENERAL MOTORS COMPANY

Body Rear Corner Upper Garnish Molding Cap (1) - Remove
Body Rear Corner Upper Garnish Molding Bolt (2) - Remove
Body Rear Corner Upper Garnish Molding (3) - Reposition
Courtesy of GENERAL MOTORS COMPANY

Cargo Tie Down Loop Trim Cover (1) - Remove [2x]
Cargo Tie Down Loop Bolt (2) - Remove [2x]
Cargo Tie Down Loop (3) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Load Floor Trim Panel (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Rear Compartment Floor Panel Front Trim (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Rear Compartment Floor Stowage Compartment Divider Retainer (1) - Remove [4x]
Rear Compartment Floor Stowage Compartment Divider (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Liftgate Lock Striker Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Rear End Trim Finish Panel (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Quarter Lower Rear Trim Panel- Left Side (1) - Remove
Disconnect the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector (1) - Remove
Rear Gate Module (2) - Remove