Installation Procedure
Catalytic Converter Front Heat Shield- Inner (1) - Install
- CAUTION:
Refer to Fastener Caution .
Turbocharger Heat Shield Bolt (1) - Install and tighten [2x] - Fastener Specifications
Catalytic Converter Front Heat Shield- Outer (1) - Install
- NOTE:
Using a torque adapter may be helpful for bolt access.
Turbocharger Heat Shield Bolt (1) - Install and tighten [4x] - Fastener Specifications
- CAUTION:
Refer to Component Fastener Tightening Caution .
NOTE:A special anti-seize compound is used in the HO2S threads. The compound consists of liquid graphite and glass beads. The graphite tends to burn away, but the glass beads remain, making the sensor easier to remove. New, or service replacement sensors already have the compound applied to the threads. If the sensor is removed from an exhaust component and if for any reason the sensor is to be reinstalled, the threads must have anti-seize compound applied before reinstallation. Adhesives, Fluids, Lubricants, and Sealers
Using a suitable tool, install and tighten the heated oxygen sensor (1). Fastener Specifications
- Connect the electrical connector.
Oil Filler Cap (1) - Remove
Intake Manifold Cover (1) - Install
- Oil Filler Cap - Install
Air Cleaner Assembly (1) - Install
- Connect the electrical connector and install the wiring harness retainers as necessary.
Air Cleaner Outlet Duct Clamp (1) - Tighten - Fastener Specifications