Installation Procedure
Windshield Wiper System Module (3) - Install
- Connect the electrical connector.
- Windshield Wiper System Module Bolt (2) - Install and tighten - Fastener Specifications
- Windshield Wiper System Module Bolt (1) - Install and tighten - Fastener Specifications
Windshield Wiper System Module Shield (1) - Install
Air Inlet Grille Panel (2) - Install
- Air Inlet Grille Panel Retainer (1) - Install [8x]
Windshield Washer Pump Hose (1) @ Windshield Washer Nozzle Hose (2) - Connect
Hood Rear Outer Air Inlet Seal- Left Side and Right Side (2) - Install [2x]
- Hood Rear Outer Air Inlet Seal Retainer- Left Side and Right Side (1) - Install [2x]
Air Inlet Grille Panel Extension- Left Side and Right Side (1) - Install [2x]
- Clean the wiper motor pivot shaft knurls with a soft wire brush before installing a new wiper arm.
- Position the wiper arm on the wiper motor pivot shaft.
Windshield Wiper Arm (3) - Install [2x]
- Windshield Wiper Arm Nut (2) - Install and tighten [2x] - Fastener Specifications
- Windshield Wiper Arm Nut Cap (1) - Install [2x]
- Align the windshield wiper arms, if necessary. Windshield Wiper Arm Adjustment
CAUTION:
Refer to Fastener Caution .