Control Module Setup

To program a replacement control module, perform the following procedure:

NOTE:

Steps 1-2 must be performed BEFORE the old K47B Power Transfer Unit Actuator Control Module is removed from the vehicle.

1. Access the Service Programming System (SPS) and follow the on-screen instructions.
2. On the SPS Supported Controllers screen, select K20 Engine Control Module - DSAM Prepare Module for Removal and follow the on-screen instructions.
3. Replace the necessary driveline component(s).
4. On the SPS Supported Controllers screen, select K20 Engine Control Module - DSAM Setup and follow the on-screen instructions.
5. Clear DTCs.