Common Specs And Procedures Index

EQUINOX AND TERRAIN COMMON SPECS AND PROCEDURES

SYSTEM		SPECIFICATION/PROCEDURE
Air Conditioning
Service
Torque
Wheel Driveshaft Nut
Front		First Pass: 285 N.m (210 lb-ft) Second Pass: loosen 360 degrees Final Pass: 250 N.m (185 lb-ft)
Rear		First Pass: 150 N.m (111 lb-ft) Second Pass: Loosen 45 degrees Final Pass: 250 N.m (185 lb-ft)
Battery
Brakes
Bleeding Sequence		Manual - RIGHT REAR, LEFT REAR, RIGHT FRONT, LEFT FRONT See . Pressure - RIGHT REAR, LEFT REAR, RIGHT FRONT, LEFT FRONT See
Disc Brakes
	Service Specifications
	Torque
Charging
Generator
Torque
Drive Belts
Adjustment		Serpentine belt used, not adjustable.
Drive Belt Routing		See the figure under
Engine Cooling
General Service Specifications
	Radiator Cap Pressure
	Thermostat R & I

	Water Pump R & I

Engine Mechanical
	Compression
	Oil Pressure	Oil Pressure - @Idle and 85°C (185°F) or more Greater than 180 kPa (26.11 psi) At idle
	Overhaul
	Torque
Fluid Specifications		See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button.
Flex Plate Torque		First Pass - 20 N.m (15 lb ft) Second Pass - 30 N.m (22 lb ft) Final Pass - Additional 70 degrees
Fuel System
Pressure Specification		Running - 345 - 415 kPa (50 - 60 PSI)
	Fuel Pressure Test Procedure
	Fuel Filter Location	Fuel filter is part of the fuel tank fuel pump module
	Fuel Filter R & I	or
Ignition
Firing Order & Cylinder Identification
Ignition Wires (Resistance)		Coil on plug
Ignition Wires (Routing)		Coil on plug.
Spark Plug
(See parts catalog)
	Gap	0.024 - 0.028 in (0.60 - 0.70 mm)
	Torque	17 N.m (13 lb ft)
Starting
Starter
Starter R & I		or
Torque
Wheel Alignment
	Adjustment Specifications
	Torque
Wheel & Tire
Wheel Lug Nut Torque		140 N.m (103 lb ft) For tightening sequence, please see Wheel Nut Tightening Sequence figure under