UHF - VKM Sensor Position Learn
WARNING: This page is about a different car, the 2024 Chevrolet Silverado EV. However, it is still accessible from the selected car via links, so may be relevant.
To complete a sensor learn, perform the following procedure:
NOTE:
- This procedure needs to be completed any time a component of the Digital Key system is replaced.
- Connect a scan tool to the vehicle and access SPS.
- Select the SPS application and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K183 UHF Short Range Low Energy Remote Control Access Transceiver.
- Select Setup to initiate the UHF - VKM Sensor Position Learn.
- Follow the on-screen instructions.
- With a scan tool, clear any DTCs.
- If the sensor learn was unsuccessful due to timing out, disconnect and reconnect the battery and attempt the learn procedure again.
NOTE: