Solenoid Test
NOTE:
Perform solenoid test before testing starter relay circuit and starter relay. Ensure A/T is in Park position or M/T is in Neutral position and parking brake is applied.
- Disable vehicle ignition system. See DISABLING/ENABLING IGNITION SYSTEM.
- Ensure battery is fully charged. Ensure solenoid connections are not loose or corroded. Starter relay is located within Power Distribution Center (PDC). Locate and remove starter relay. See Fig 1.
- Connect a remote starter switch or jumper wire between starter relay connector terminal No. 87 and positive battery post. See Figure. If engine cranks, solenoid and starter are good. Go to STARTER RELAY CIRCUIT TEST.
- If engine fails to crank, or if solenoid chatters, check wiring and connectors from starter relay connector to starter solenoid terminal for loose or corroded connections. Clean and retest. If engine still fails to crank, remove starter and proceed to BENCH TESTING.