LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 1996 >> Sebring JXi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 2.4L >> Trouble Code Tests >> Test TC-69A - Injector No. 5 Control Circuit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test TC-69A - Injector No. 5 Control Circuit

NOTE: For connector terminal ID, see CONNECTOR IDENTIFICATION  Directory. For wiring diagram, see WIRING DIAGRAMS article.
  1. Turn ignition off. Disconnect injector harness 4-pin connector.
  2. Using an external ohmmeter, check resistance on injector harness connector (PCM side) between Gray wire and Dark Green/Orange wire. If resistance is 10-16 ohms, go to next step. If resistance is not 10-16 ohms, perform TEST TC-69B.
  3. Move ohmmeter lead from Dark Green/Orange wire to ground. Observe ohmmeter reading. If ohmmeter reading is 5 ohms or more, go to next step. If ohmmeter reading less than 5 ohms repair short to ground on injector No. 5 driver circuit Gray wire. Perform TEST VER-2A.
  4. Turn ignition on. Using scan tool, actuate ASD relay. Using scan tool in voltmeter mode, check voltage on injector connector (PCM side) ASD relay output circuit Dark Green/Orange wire. If voltage cycles high and low, go to next step. If voltage does not cycle high and low, repair open Dark Green/Orange wire. Perform TEST VER-2A.
  5. Turn ignition off. Disconnect Powertrain Control Module (PCM) connector. Using scan tool in ohmmeter mode, check resistance on PCM connector terminal No. 15 injector No. 5 driver circuit Gray wire. If resistance is 5 ohms or more, go to next step. If resistance is less than 5 ohms, repair short to ground on injector No. 5 driver circuit. Perform TEST VER-2A.
  6. Using an external ohmmeter, check resistance of injector No. 5 driver circuit Gray wire between injector connector (PCM side) and PCM connector terminal No. 15. If resistance is less than 5 ohms, replace PCM. Perform TEST VER-2A. If resistance is 5 ohms or more, repair open injector driver No. 5 circuit. Perform TEST VER-2A.