LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 1996 >> Sebring JXi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 2.4L >> Trouble Code Tests >> Test TC-69B - Injector No. 5 Control Circuit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test TC-69B - Injector No. 5 Control Circuit

NOTE: For connector terminal ID, see CONNECTOR IDENTIFICATION  Directory. For wiring diagram, see WIRING DIAGRAMS article.
  1. It may be necessary to remove intake plenum for access to injector connectors. Reconnect injector harness 4-pin connector. Disconnect injector No. 5 connector. Turn ignition on. Using scan tool, actuate ASD relay.
  2. Using scan tool in voltmeter mode, check voltage on injector No. 5 connector ASD relay output circuit Dark Green/Orange wire. If voltage cycles high and low, go to next step. If voltage does not cycle high and low, repair open ASD relay output circuit. Perform TEST VER-2A.
  3. Turn ignition off. Using an external ohmmeter, check resistance of injector No. 5 driver circuit Gray wire between injector No. 5 connector and PCM connector terminal No. 15. If resistance is less than 5 ohms, replace injector No. 5. Perform TEST VER-2A. If resistance is 5 ohms or more, repair open injector No. 5 driver circuit. Perform TEST VER-2A.
scientia non olet · About LEMON Manuals