Brake Switch
WARNING: This page is about a different variant/trim than selected.
Disconnect brake switch 6-pin connector. Using an ohmmeter, check for continuity at brake switch. See Fig 1. If continuity is not as specified in BRAKE SWITCH CONTINUITY table, check brake switch adjustment. If brake switch adjustment is okay, replace defective brake switch.
BRAKE SWITCH CONTINUITY
| Switch Plunger Position | Check Between Terminals No. | Continuity |
|---|---|---|
| Released | 5 & 6 | Yes |
| Depressed | 1 & 2 | Yes |
| Depressed | 3 & 4 | Yes |