LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 1998 >> Cirrus >> Repair and Diagnosis >> Engine Performance >> Engine Controls - Adjustments - 2.5L Engine >> Throttle Position Sensor >> V6 Throttle Position Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

V6 Throttle Position Sensor

NOTE: Throttle Position (TP) sensor is nonadjustable. Use following procedure to check TP sensor calibration. For complete testing of TP sensor and wiring circuit, see appropriate TESTS W/CODES article.
  1. Remove components for access to electrical connector at TP sensor mounted on throttle body. With electrical connector installed on TP sensor, turn ignition on with engine off. DO NOT start engine.
  2. Using Digital Volt-Ohmmeter (DVOM), check voltage at center terminal on electrical connector for TP sensor with throttle valve closed (idle position). Voltage should be greater than .60 volt.
  3. Slowly open throttle to full throttle and note voltage reading. Voltage should smoothly increase to less than 4.5 volts. Replace TP sensor if voltage is not within specification.
scientia non olet · About LEMON Manuals