Power Door Lock Test 2C - Door Lock Driver Short Circuit

NOTE: Perform POWER DOOR LOCK TEST 2A before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION . For wiring diagrams, refer to WIRING DIAGRAMS . Perform, after each repair, TEST VER-1A - VERIFICATION PROCEDURE .

CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.

NOTE: Door lock driver terminals No. 12 and 13 on BCM 20-pin connector do not apply to Sebring Convertible.

Disconnect BCM 20-pin connector located at junction block and ensure connector is clean and not damaged. See Figure in CHIME TEST 3A. Using scan tool in ohmmeter mode, measure resistance at terminals No. 10 (Orange/Black wire), No. 11 (Orange/White wire), No. 12 (Orange/Tan wire) and No. 13 (Orange/Brown wire) on BCM 20-pin connector.
If resistance is less than 5 ohms, repair shorted door lock driver circuit, replace fuse No. 9 and BCM (relay in BCM will be damaged). If resistance 5 ohms or greater, replace BCM and replace fuse No. 9.