Removal & Installation
- The PCM is located between driver's side front fender and power distribution center, near battery. See Fig 1. First disconnect negative and then positive battery cables from battery.
- Remove 2 screws on side of power distribution center that secure power distribution center to mounting bracket. Remove heat shield from outside of battery and remove battery.
- Rotate power distribution center toward the engine to disengage from rear mounting bracket. Pull power distribution center toward rear of vehicle to disengage from front mounting bracket.
- Allow power distribution center to lay aside for access to PCM. Remove electrical connectors from PCM. Electrical connectors may be removed by squeezing tabs on electrical connector together and pulling electrical connector from PCM. Remove bolts and PCM. To install, reverse removal procedure.
Courtesy of CHRYSLER CORP.