Memory Set Switch Replacement

REMOVAL
1. Disconnect and isolate the negative battery cable remote terminal from the remote battery post.

WARNING: SOME VEHICLES ARE EQUIPPED WITH SEATBACK MOUNTED AIRBAGS. BEFORE ATTEMPTING TO DIAGNOSE OR SERVICE ANY SEAT OR POWER SEAT SYSTEM COMPONENT YOU MUST FIRST DISCONNECT AND ISOLATE THE BATTERY NEGATIVE CABLE. THEN WAIT TWO MINUTES FOR THE SYSTEM CAPACITOR TO DISCHARGE BEFORE FURTHER SYSTEM SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO DO SO COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

Memory And Heated Switch Location:

2. Unscrew the side shield on the seat, either driver or passenger side.
3. From the bottom, disengage the switch and gently rock through the opening.

INSTALLATION
1. Install the switch in the seat cushion side shield.
2. Install the seat cushion side shield. Refer to Body for the procedure.
3. Connect the negative battery cable remote terminal.