LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2001 >> Intrepid Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Engine Controls - Self-Diagnostics) >> Programming >> Sentry Key Immobilizer Module >> Programming Ignition Keys To SKIM
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Programming Ignition Keys To SKIM

WARNING: This page is about a different car, the 2004 Chrysler Intrepid, 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect DRBIII® scan tool to Data Link Connector (DLC). See Figure. Place transmission in Park or Neutral. Turn the ignition on, with the engine off.
  2. With DRBIII® scan tool, select THEFT ALARM, SKIM THEN MISCELLANEOUS.
  3. Select PROGRAM IGNITION KEYS.
    4. NOTE: A maximum of 8 keys can be learned by each SKIM at one time. Once a key is learned to SKIM, the key cannot be transferred to another vehicle.
  4. Enter secured access mode by entering the vehicle 4-digit Personal Identification Number (PIN). Follow DRBIII® scan tool prompts. If ignition key programming is unsuccessful, the DRBIII® scan tool will display one of the following messages:
    • Programming Not Attempted -  The DRBIII® scan tool attempts to read the programmed key status and there are no keys programmed in the SKIM memory.
    • Programming Key Failed -  The SKIM is unable to program a key because it has a faulty transponder or the key is programmed to another vehicle.
    • 8 Keys Already Learned, Programming Not Done -  SKIM transponder identification memory is full. Obtain up to 8 keys to be programmed. Using the DRBIII® scan tool, erase all ignition keys by selecting MISC and ERASE ALL CURRENT IGN KEYS, then return to step  2.
    • Learned Key In Ignition -  Ignition key transponder identification is currently programmed in SKIM memory.
scientia non olet · About LEMON Manuals