LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2001 >> Intrepid Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Wiper System & Washer System) >> System Tests >> Wipers Run At Low Speed With Switch In High Speed Position
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Wipers Run At Low Speed With Switch In High Speed Position

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, 2003 Chrysler 300M, and 2002 Dodge Intrepid. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove HIGH/LOW wiper relay from power distribution center. See Figure . Substitute with known-good relay. If system operates normally, replace HIGH/LOW wiper relay. If system still operates at low speed in high position, go to next step.
  2. Disconnect Body Control Module (BCM) White connector C3. Check continuity in Violet wire between HIGH/LOW wiper relay connector terminal "C" and BCM connector C3 terminal No. 12. See Figure . If continuity does not exist, repair open in Violet wire. If continuity exists, go to next step.
  3. Check wiper/washer switch. See WIPER/WASHER SWITCH  under COMPONENT TESTS. If wiper/washer switch is defective, replace wiper/washer switch. See WIPER SWITCH  under REMOVAL & INSTALLATION. If wiper/washer switch is okay, check for binding linkage. See WIPERS RUN SLOWLY AT ALL SPEEDS  .
scientia non olet · About LEMON Manuals