LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules - Except Coupe >> System Tests >> Instrument Cluster Systems >> Brake Warning Indicator Not Operating Properly
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Brake Warning Indicator Not Operating Properly

NOTE: After making any repairs, perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  1. Perform self-test on instrument cluster. Press and hold TRIP/RESET button and turn ignition on. If brake warning indicator does not turn on for 4 seconds then turn off, go to step  3 . If brake warning indicator turns on for 4 seconds then turns off, go to next step.
  2. Turn ignition off. Remove and disconnect instrument cluster. See INSTRUMENT CLUSTER  under REMOVAL & INSTALLATION. Disconnect parking brake switch connector. Connect a jumper wire between ground and Gray/Dark Blue wire or Gray/Black wire at parking brake switch harness connector. Disconnect brake fluid level switch connector at brake master cylinder. Connect a jumper wire between ground and Gray/Black wire at brake fluid level switch harness connector. Turn on ignition. Using a test light connected to battery voltage, probe terminal No. 22 (Gray/Black wire) at instrument cluster harness connector. See Figure . If test light illuminates brightly, replace instrument cluster. If test light does not illuminate brightly, replace open or high resistance is Red brake warning indicator driver circuit. See WIRING DIAGRAMS  .
  3. Remove and disconnect instrument cluster connector. See INSTRUMENT CLUSTER  under REMOVAL & INSTALLATION. Remove and inspect Red brake warning bulb and socket. Replace bulb or socket as necessary. If bulb and socket are okay, go to next step.
  4. Turn ignition off. Using a test light connected to ground, probe terminal No. 15 (Red/White wire) at instrument cluster harness connector. See Figure . If test light does not illuminate, repair open in Red/White wire between instrument cluster and fuse No. 11 (10-amp) in junction block. Junction block is located under left side of instrument panel. If test light illuminates, replace EMIC.
scientia non olet · About LEMON Manuals