LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2001 >> Voyager Base, 2.4 B >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> System Tests >> Windshield Wiper/Washer System >> Front Wiper On/Off Relay Control Circuit Open
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Wiper On/Off Relay Control Circuit Open

NOTE: After making any repairs, perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  1. Turn ignition off. Remove wiper on/off relay from Intelligent Power Module (IPM). See Figure . Using a test light connected to ground, probe wiper on/off relay cavity terminals No. 85 and 87 in IPM. If test light illuminates brightly at both terminals, go to next step. If test light does not illuminate brightly at one or both terminals, repair open circuit between wiper on/off relay and fuse No. 4 (30-amp). See WIRING DIAGRAMS in WIPER/WASHER SYSTEMS - CARAVAN, TOWN & COUNTRY, & VOYAGER article.
  2. Install a known-good wiper on/off relay. Turn ignition on. Turn wipers on. If wipers do not operate properly, go to next step. If wipers operate properly, replace wiper on/off relay.
  3. Turn ignition off. Remove wiper on/off relay from IPM. Locate and disconnect Front Control Module (FCM). See FRONT CONTROL MODULE  under REMOVAL & INSTALLATION. Connect a jumper wire between ground and wiper on/off relay cavity terminal No. 86 in IPM. Using DVOM, measure resistance between FCM connector terminal No. 14. See Figure . If resistance is 5 ohms or less, replace FCM. If resistance is greater than 5 ohms, repair open circuit between wiper on/off relay and FCM. See WIRING DIAGRAMS in WIPER/WASHER SYSTEMS - CARAVAN, TOWN & COUNTRY, & VOYAGER article.
scientia non olet · About LEMON Manuals