Antenna Failure, COP Failure, EEPROM Failure, Internal Fault, RAM Failure, Serial Link Internal Fault Or Stack Overflow Failure

NOTE: This DTC indicates and internal SKIM fault.

NOTE: After making any repairs, perform SKIS VERIFICATION TEST under VERIFICATION TESTS.

Using scan tool, record and erase Sentry Key Immobilizer Module (SKIM) DTCs. Cycle ignition off and back on 10 times, leaving ignition in on position for a minimum of 90 seconds between each cycle. Using scan tool, read SKIM DTCs. If DTC resets, replace SKIM. See SENTRY KEY IMMOBILIZER MODULE under REMOVAL & INSTALLATION. If DTC does not reset, test is complete.