B. Replace PCM - PL Vehicles

1. Disconnect the negative battery cable.

NOTE:
To enhance customer satisfaction, remember to reset the clock when you have completed the service procedure.

2. Remove the air cleaner assembly and set it aside.

3. Disconnect the four (4) PCM electrical connectors.





4. Remove the three (3) PCM bracket fasteners (Figure 2) and then remove the PCM and bracket assembly.

5. Remove the three (3) PCM bolts, then remove the PCM and discard it (Figure 2).

6. Install the new PCM (Figure 2). Tighten the mounting bolts to 105 in-lbs (11.8 Nm).

7. Install the PCM and bracket assembly. Tighten the fasteners to 95 in-lbs (10.7 Nm).

8. Connect the four (4) PCM electrical connectors. Attach the wiring harness clip to the PCM bracket.

9. Install the air cleaner assembly.

10. Connect the negative battery cable.

11. Continue with Section E - PCM/Vehicle Data Set-up.