Removal - 3.3/3.8L
- Disconnect the negative battery cable.
- Remove the air box cover and inlet tube (Fig 1
).
Courtesy of DAIMLERCHRYSLER CORP.
- Disconnect camshaft position sensor electrical connector from the wiring harness connector (Fig 2
).
Courtesy of DAIMLERCHRYSLER CORP.
- Remove bolt holding sensor.
- Rotate sensor away from block.
- Pull sensor up out of the chain case cover. Do not pull on the sensor wiring.
There is an O-ring on the body of the sensor. The O-ring may make removal difficult. A light tap to top of sensor prior to removal may reduce force needed for removal.