LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2004 >> Crossfire V6-3.2L VIN L >> Repair and Diagnosis >> Powertrain Management >> Transmission Control Systems >> Testing and Inspection >> CAN Bus Circuit
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

CAN Bus Circuit

CAN BUS CIRCUIT





POSSIBLE CAUSES
- CAN COMMUNICATION FAILURE
- CAN C BUS (+) AND/OR CAN C BUS (-) CIRCUIT OPEN
- SHIFT LEVER ASSEMBLY

Diagnostic Test
1. CHECK FOR CAN DTCS IN OTHER MODULES





Turn the ignition on.
With the DRB III*, read the stored and active DTCs for all modules on the CAN C Bus.
Are other modules reporting CAN Bus DTCs?
Yes>>Refer to the reporting category and perform the appropriate symptom. If the PCM is reporting a CAN Bus failure, refer to the PCM tests first.
No>>Go To 2

2. CAN C BUS (+) AND/OR CAN C BUS (-) CIRCUIT OPEN





Turn the ignition off.
Disconnect the PCM harness connector. Disconnect the SLA harness connector.

Note: Check connectors - Clean/repair as necessary.

Measure the resistance of both the CAN C Bus (+) circuit and the CAN C Bus (-) circuit from the PCM harness connector to the SLA harness connector.
Is the resistance of both CAN C Bus circuits below 5.0 ohms?
Yes>>Replace the Shift Lever Assembly.
Perform NAG1 TRANSMISSION VERIFICATION TEST. Verification Tests
No>>Repair the faulty CAN C Bus circuit for an open.
Perform NAG1 TRANSMISSION VERIFICATION TEST.
scientia non olet · About LEMON Manuals