Rear Driveline Module: Installation
- Install driveline module to transmission jack. Secure module to jack.
- Using Tool 9099, load halfshafts to differential, one side at a time (Fig 1
).
Courtesy of DAIMLERCHRYSLER CORP.
- Index and install propeller shaft to driveline module flange. Install, but do not tighten, three (3) propeller shaft-to-driveline module bolts.
- Raise driveline module into position (Fig 2
).
Courtesy of DAIMLERCHRYSLER CORP.
- Install and torque module-to-cradle bolts to 102 N.m (75 ft. lbs.) (Fig 3
) (Fig 4
).
Courtesy of DAIMLERCHRYSLER CORP.
Courtesy of DAIMLERCHRYSLER CORP.
- Torque propeller shaft-to-driveline module bolts to 54 N.m (40 ft.lbs.)
- Raise exhaust system into position and install hanger/brackets.
- Fill differential with 0.7L (0.74 qts.) of Mopar(R) Gear and Axle Lubricant (75W-90). (Refer to STANDARD PROCEDURE - DIFFERENTIAL ASSEMBLY FLUID CHANGE
)
- Fill overrunning clutch housing with 0.58L (0.61 qts.) of Mopar(R) ATF+4. (Refer to STANDARD PROCEDURE - DIFFERENTIAL ASSEMBLY FLUID CHANGE
)