Standard Procedure - Quick Learn Procedure

The quick learn procedure requires the use of the DRBIII® scan tool. This program allows the PCM/TCM to recalibrate itself. This will provide the best possible transaxle operation.

• Transaxle Assembly Replacement
• Powertrain/Transmission Control Module Replacement
• Solenoid/Pressure Switch Assembly Replacement
• Clutch Plate and/or Seal Replacement
• Valve Body Replacement or Recondition

To perform the Quick Learn Procedure, the following conditions must be met:

• The brakes must be applied
• The engine speed must be above 500 rpm
• The throttle angle (TPS) must be less than 3 degrees
• The shift lever position must stay until prompted to shift to overdrive
• The shift lever position must stay in overdrive after the Shift to Overdrive prompt until the DRBIII® indicates the procedure is complete
• The calculated oil temperature must be above 60° and below 200°

1. Plug the DRBIII® scan tool into the diagnostic connector. The connector is located under the instrument panel.
2. Go to the Transmission screen .
3. Go to the Miscellaneous screen .
4. Select Quick Learn Procedure. Follow the instructions of the DRBIII® to perform the Quick Learn Procedure.