Standard Procedure - TCM Quick Learn

STANDARD PROCEDURE - QUICK LEARN PROCEDURE
The quick learn procedure requires the use of the DRBIII scan tool. This program allows the electronic transaxle system to recalibrate itself. This will provide the best possible transaxle operation.

NOTE: The quick learn procedure should be performed if any of the following procedures are performed:

- Transaxle Assembly Replacement
- Transmission Control Module Replacement
- Powertrain Control Module Replacement (NGC-Equipped Models)
- Solenoid/Pressure Switch Assembly Replacement
- Clutch Plate and/or Seal Replacement
- Valve Body Replacement or Recondition

To perform the Quick Learn Procedure, the following conditions must be met:
- The brakes must be applied
- The engine speed must be above 500 rpm
- The throttle angle (TPS) must be less than 3 degrees
- The shift lever position must stay until prompted to shift to overdrive
- The shift lever position must stay in overdrive after the Shift to Overdrive prompt until the DRBIII indicates the procedure is complete
- The calculated oil temperature must be above 60 °F and below 200 °F

1 Plug the DRBIII scan tool into the diagnostic connector. The connector is located under the instrument panel.
2 Go to the Transmission screen.
3 Go to the Miscellaneous screen.
4. Select Quick Learn Procedure. Follow the instructions of the DRBIII to perform the Quick Learn Procedure.