Standard Procedure - Quick Learn Procedure
WARNING: This page is about a different car, the 2004 Dodge Grand Caravan, 2004 Dodge Caravan, and 2004 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
The quick learn procedure requires the use of the DRBIII® scan tool. This program allows the PCM/ TCM to recalibrate itself. This will provide the best possible transaxle operation.
NOTE:
The quick learn procedure should be performed if any of the following procedures are performed:
- Transaxle Assembly Replacement
- Powertrain/Transmission Control Module Replacement
- Solenoid/Pressure Switch Assembly Replacement
- Clutch Plate and/or Seal Replacement
- Valve Body Replacement or Recondition
To perform the Quick Learn Procedure, the following conditions must be met:
- The brakes must be applied
- The engine speed must be above 500 rpm
- The throttle angle (TPS) must be less than 3 degrees
- The shift lever position must stay until prompted to shift to overdrive
- The shift lever position must stay in overdrive after the Shift to Overdrive prompt until the DRBIII® indicates the procedure is complete
- The calculated oil temperature must be above 60° and below 200°
- Plug the DRBIII® scan tool into the diagnostic connector. The connector is located under the instrument panel.
- Go to the Transmission screen.
- Go to the Miscellaneous screen.
- Select Quick Learn Procedure. Follow the instructions of the DRBIII® to perform the Quick Learn Procedure.