Diagnostic Test

Fig 1: Connecting Scan Tool & Turning Ignition On

Courtesy of DAIMLERCHRYSLER CORP.

Turn the ignition on.

With the DRB III®, program the ORC.

1. On the parts control modules menu, program the side airbag equipment to YES.
2. On the parts control modules menu, program the seat belt buckle equipment to YES.
3. On the parts control modules menu, program the seat occupied recognition equipment to YES.
4. Set the front passenger airbag to YES.

Turn the ignition off.

Turn the ignition on.

Erase DTCs, the Airbag Warning Indicator Light should flash to indicate that the programming procedure was successful.

With the DRB III®, read DTCs.

Does the DRB III® display a Programming Does Not Correspond To The Vehicle Equipment DTC? 

Yes 

1. Attempt the programming procedure again or replace the Occupant Restraint Controller. (Refer to ELECTRICAL/RESTRAINTS/OCCUPANT RESTRAINT CONTROLLER - REMOVAL) .
   WARNING: IF THE OCCUPANT RESTRAINT CONTROLLER IS DROPPED AT ANY TIME, IT MUST BE REPLACED.
2. Perform AIRBAG VERIFICATION TEST .

No 

1. The condition that caused this DTC to set is currently not present.