LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2005 >> Pacifica Base, 3.5 4 >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Power Liftgate System >> Full Open Switch >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Full Open Switch: Installation

NOTE: Be certain the wires are reinstalled in the correct wire cavities. Failure to do so could result in damage to components. Refer to appropriate wiring information if uncertain.
  1. Perform a wiring repair on the full open switch wires, or install new terminals on the wire ends and reinstall in the main drive unit electrical connector. Be certain to follow the approved procedure in WIRING DIAGRAM INFORMATION .
  2. Install the full open switch on the drive unit assembly.
  3. Connect the negative battery cable.
  4. Using an appropriate scan tool, check and erase any power liftgate control module diagnostic trouble codes.
  5. Verify power liftgate system and full open switch operation. Cycle the power liftgate through one complete open and close cycle, this will allow the power liftgate control module to relearn its cycle with the new components.
  6. Install the left rear D-pillar trim panel on the vehicle. Refer to INTERIOR/EXTERIOR for the procedure.
scientia non olet · About LEMON Manuals