LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2006 >> Sebring GTC >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules >> Body Control Module >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Body Control Module: Installation

NOTE: If BCM is replaced, the VTSS must be enabled in the new BCM via the scan tool in order to start the vehicle.
  1. Snap the remote keyless entry module onto the BCM.
  2. Connect BCM to the Junction Block.
  3. Connect the BCM and junction block together with the four screws.
  4. Install the Junction Block/BCM into vehicle.
  5. Connect BCM wire connectors and install the assembly onto instrument panel.
  6. Install the Junction Block/BCM by pushing straight up.
  7. Install the Junction Block three mounting screws.
  8. Install the wire harness connectors to the Junction Block.
  9. Install the silencer.
  10. Install the left lower instrument panel trim.
  11. Install the power mirror switch bezel, radio bezel and small bezel to the right of the steering column.
  12. Install the left end cover.
  13. Connect the remote battery negative cable to the remote terminal on the shock tower.
scientia non olet · About LEMON Manuals