LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2006 >> Sebring GTC >> Repair and Diagnosis >> Body & Frame >> Windows >> Interior & Exterior >> Sunroof >> Sunroof Module Assembly >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Sunroof Module Assembly: Installation

NOTE: There are locating pins on the roof panel near the front corners of the sunroof opening that will help position the sunroof module correctly.
  1. With the Glass panel in the fully closed position.
  2. Raise rear end of sunroof module assembly and guide into position and start fasteners.
  3. Tighten the fasteners holding the sunroof module to roof panel. Tighten the fasteners to 11 N.m (97 in. lbs.) torque.
  4. Connect the drain tubes to the sunroof housing.
  5. Connect wire harness.
  6. Set headliner into position.
  7. Connect battery negative cable.
  8. Connect express module, drive motor, and control switch wire connectors.
  9. Test sunroof operation, adjust as necessary.
  10. Finish installing the headliner.
  11. Install sunroof opening trim lace. (Refer to BODY/SUNROOF/OPENING TRIM LACE - INSTALLATION) .
scientia non olet · About LEMON Manuals