LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2006 >> Sebring GTC >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System (Service Information) >> Traction Control Switch >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Traction Control Switch: Installation

  1. Install switch through top of upper shroud and snap into place. See Figure.
  2. Install the upper and lower steering column shrouds onto the lock housing of the steering column. As upper shroud is installed, guide traction control "OFF" switch wiring pigtail down right side of column and connect wiring connector to column harness.
  3. Install and securely tighten screws attaching steering column shrouds to column lock cylinder housing to 1.9 N.m (17 in. lbs.) torque. See Figure.
  4. Install instrument panel trim bolster below steering column. (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL TRIM - INSTALLATION) .
  5. Connect remote ground cable to ground stud on left front shock tower.
  6. Close hood.
  7. Connect DRBIII® scan tool to diagnostic data link connector and check for any faults.
  8. Road test vehicle checking operation of traction control and switch.
scientia non olet · About LEMON Manuals