DTC 1175: Steering Angle Sensor Momentarily Not Initialized

Fig 1: Steering Angle Sensor Circuit Schematic

Courtesy of CHRYSLER LLC

When Monitored: With the ignition on. The Controller Antilock Brake (CAB) monitors the status of the Steering Angle Sensor.
Set Condition: The DTC will set only if the Steering Angle Sensor is not calibrated.

Possible Causes
UNCALIBRATED STEERING ANGLE SENSOR

For a complete Antilock Brake System (ABS) circuit diagram, see SCHEMATICS AND DIAGRAMS .

NOTE: This DTC will possibly set if the battery has been disconnected. Before performing any diagnostics confirm that the steering angle sensor is calibrated correctly. If the DTC is current, and the battery has been previously disconnected, perform the following procedure to recalibrate the steering angle sensor.

Turn the ignition switch on.
Rotate the steering wheel to the center position.
Rotate the steering wheel to the full left stop.
Rotate the steering wheel to the full right stop.
Rotate the steering wheel back to the center position.
Sensor recalibration is now complete, and the ESP/BAS light should be off.