Sensor-O2 - 3.8L

Fig 1: Upstream O2 Sensor

Courtesy of CHRYSLER LLC

1 - Item_1xftjhxfdj

2 - Item _2tjsryjy

NOTE: When replacing an O2 Sensor, the PCM RAM memory must be cleared, either by disconnecting the PCM C-1 connector or momentarily disconnecting the Battery negative terminal. The NGC learns the characteristics of each O2 heater element and these old values should be cleared when installing a new O2 sensor. The customer may experience driveability issues if this is not performed.

After removing the sensor, the threads must be cleaned with an 18 mm X 1.5 + 6E tap. If reusing the original sensor, coat the sensor threads with an anti-seize compound such as Loctite 771- 64 or equivalent. New sensors have compound on the threads and do not require an additional coating. Tighten the sensor to 41 N.m (30 ft. lbs.) torque.

Fig 2: O2 Sensor Connector
Courtesy of CHRYSLER LLC
Connect the heated oxygen sensor electrical connector.
Connect the negative battery cable.