Torque Specifications

TORQUE









CRANKSHAFT MAIN BEARING BOLT TORQUE SEQUENCE

Clean and oil all cap bolts. Install all cap bolts and alternately tighten in two steps using the following sequence.




- Step 1 - 27 Nm ( 20 ft. lbs.).
- Step 2 - Turn main cap bolts an additional 90°.
- Install the crossbolts with new washer/gasket. Starting with crossbolt A torque each crossbolt to 28 Nm ( 21 ft. lbs.).
- Repeat crossbolt torque procedure.

CRANKSHAFT PULLEY

Crankshaft Pulley Bolt 176 Nm (129 ft. lbs.)