Section 167 (Cellular Systems, Entertainment Systems & Navigation Systems (Service Information)): Radio: Installation: Installation

WARNING: This page is about a different car, the 2010 Dodge Avenger and 2010 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disconnecting/Connecting Radio Electrical Connectors

Courtesy of CHRYSLER LLC

Connect the electrical connectors to the radio.
Connect the antenna connector(s) to the radio.
Install radio and mounting fasteners.
Install instrument panel center bezel trim. Refer to Body/Instrument Panel/BEZEL, Instrument Panel - Installation .
Connect the battery negative cable.
NOTE: REQ RADIO , After installation of the radio, remove the radio from "Transportation Mode" by pulling the IOD fuse or using the scan tool and perform a battery reset. For Battery Reconnection procedure, refer to INSTALLATION .