Diagnostic Test

1. Ignition on, engine not running.
2. With the scan tool, select View DTCs in the Steering Control Module.

   Is the DTC status Active at this time?

   Yes 

   • Go to step  2

   No 

   • Go to step  4

1. Turn the ignition off.
2. Replace the Steering Column Tilt/Telescope Switch in accordance with the Service Information.
3. Turn the ignition on.
4. Move the Steering column tilt switch to the up and down positions several times.
5. With the scan tool, clear stored DTCs in the Steering Control Module.
6. With the scan tool, select Data Display and view the Steering column up and the Steering column down switch data.
7. While monitoring the Steering column up and the Steering column down switch data, move the Steering column tilt switch to the up and down positions several times.

   Does the Steering column switch data change from Set to Not Set as the switch is moved to each position?

   Yes 

   • Test complete.

   No 

   • Go to  3

Repair 

• Replace the Steering Control Module (SCM) in accordance with the Service Information.
• Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .

1. The conditions necessary to set this DTC are not present at this time.
2. While monitoring the scan tool data relative to this circuit, wiggle test the component and connectors and move the switch to each position.
3. Look for the data to change other than as expected or for the DTC to reset during the test.

   Were any problems found?

   Yes 

   • Repair as necessary.
   • Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .

   No 

   • Test complete.