B. Reprogram the PCM Module

1. From the "Vehicle View" screen, click on the PCM icon.

2. From the "PCM View" screen, compare the "Current ECU Flash Number" with the "New Part Number" listed on the "sort table". If the "Current ECU Flash Number" is the same as the "New Part Number" continue to Step 10. If the part numbers are not the same, continue to Step 3.

3. With the cursor over the desired flash file, click the small green arrow button on the right side of the screen.

4. From the "ECU Flash" screen follow the wiTECH screen instructions to complete the flash.

5. Once the flash is complete click the "OK" button on the "ECU Flash" screen.

6. Select "Vehicle View" from the "PCM View" screen.

7. From the "All DTC's" tab, select the "Clear Stored DTC's" button.

8. Select "OK" from the pop-up text box.

9. From the "PCM View" screen, compare the "Current ECU Flash Number" with the "New Part Number" listed on the "sort table". If the "Current ECU Flash Number" is the same as the "New Part Number" the flash is complete, continue to Step 10. If the part numbers are not the same, repeat Steps 3 through 9.

10. Turn the ignition to the "OFF" position, remove the wiPOD and battery charger from the vehicle.

11. Continue with Section E. Install the Authorized Modifications Label.