Charging System (Service Information): Generator: Installation: 2.0L/2.4L

Fig 1: Generator Removal/Installation

Courtesy of CHRYSLER GROUP, LLC

1. Move the A/C compressor to the side to install the generator.
   Fig 2: Rotate Generator

   Courtesy of CHRYSLER GROUP, LLC
2. Rotate the generator and set it in place.
   Fig 3: Battery Stud Location

   Courtesy of CHRYSLER GROUP, LLC
3. Make sure the battery terminal (1) is in front of the A/C line (2).
   Fig 4: Lower Mounting Bolt

   Courtesy of CHRYSLER GROUP, LLC
4. Loosely install the lower mounting bolt.
   Fig 5: Upper Mounting Bolt

   Courtesy of CHRYSLER GROUP, LLC
5. Loosely install the upper mounting bolt.
6. Tighten the bolts to 54 N.m (40 ft. lbs.).
   Fig 6: Battery Cable Connection

   Courtesy of CHRYSLER GROUP, LLC
7. Install the B+ terminal nut and wire and tighten to 10 N.m (88.5 in. lbs.).
   Fig 7: Field Connection

   Courtesy of CHRYSLER GROUP, LLC
8. Plug in the field circuit to the generator.
   Fig 8: Idler Pulley Removal/Install

   Courtesy of CHRYSLER GROUP, LLC
9. Install idler pulley and tighten the bolt.
10. Install the serpentine belt. Refer to BELT, SERPENTINE, INSTALLATION .
11. Install the splash shield.
    Fig 9: Lower Air Dam/Belly Pan

    Courtesy of CHRYSLER GROUP, LLC
12. Install the lower air dam.
13. Lower the vehicle.
14. Connect the negative battery cable.