LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2019 >> 300 C >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Adaptive Cruise Control (Acc) >> Installation >> Module And Bracket
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module And Bracket

  1. Check to be certain that the two rivet nuts are properly installed and in good condition in front bumper support bar.
  2. Position the mounting bracket to the bumper support bar.
    GC0170147Courtesy of CHRYSLER GROUP, LLC
  3. Install the fasteners (2) that secure the mounting bracket (1) to the support bar. Tighten the fasteners to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
  4. Install the energy absorber.
    GC0170255Courtesy of CHRYSLER GROUP, LLC
  5. Connect the wiring harness connector (1) to the ACC sensor module.
  6. Install the front fascia. Refer to FASCIA, FRONT, INSTALLATION .
  7. Connect the negative battery cable.
  8. Perform the ACC module alignment procedure. Refer to MODULE, ADAPTIVE CRUISE CONTROL (ACC), MODULE PROGRAMMING .
scientia non olet · About LEMON Manuals