Diagnostic Test
- VERIFY DTC IS ACTIVE NOTE:
Make sure the battery voltage is between 10 and 16 volts before proceeding.
- With the scan tool, read the Steering Column Control Module (SCCM) DTCs and record on the repair order.
Is the DTC active?
Yes
- Go to 2
No
- Perform the STORED LOST COMMUNICATION DTCS diagnostic procedure. Refer to STORED LOST COMMUNICATION DTCS.
- With the scan tool, read the Steering Column Control Module (SCCM) DTCs and record on the repair order.
- CHECK FOR ANY OF THE FOLLOWING ACTIVE DTCS
- With the scan tool, read all active DTCs from all modules.NOTE:
Check for BCM configuration, CAN C hardware electrical, VIN Missing/Mismatch, battery or ignition related DTCs.
Does the scan tool display any active DTCs to the conditions listed above?
Yes
- Perform the appropriate diagnostic procedure.
No
- Go to 3
- With the scan tool, read all active DTCs from all modules.
- VERIFY THE INSTRUMENT CLUSTER (IC) IS ACTIVE ON THE BUS
- Turn the ignition on.
- With the scan tool, verify the IC is active on the bus.
Is the IC active on the bus?
Yes
- Go to 4
No
- Perform the NO RESPONSE FROM IC (INSTRUMENT CLUSTER) diagnostic procedure. Refer to DIAGNOSIS AND TESTING .
- CHECK FOR ADDITIONAL COMMUNICATION RELATED DTCS
- With the scan tool, read all the DTCs.
Is there more than one module with active DTCs "Logged Against" the IC?
Yes
- Replace/update the Instrument Cluster (IC) in accordance with the Service Information. Refer to REMOVAL and INSTALLATION .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST.
No
- Go to 5
- With the scan tool, read all the DTCs.
- CLEAR DTC IN MODULE SETTING FAULT
- With the scan tool, select the module setting the DTC against the IC.
- With the scan tool, erase the DTCs.
Did the DTC return?
Yes
- Replace/update the module that set this DTC in accordance with the Service Information.
- Perform the appropriate verification test for the module being replaced. If there is no verification test for the associated module perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST.
No
- The condition is not present at this time. Using the appropriate SYSTEM WIRING DIAGRAMS as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the appropriate verification test for the module. If there is no verification test for the associated module perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST.