Gen 5
This procedure must be performed in the following cases:
- Removing / Installing the radar sensor.
- Warning light indicated the failure of the radar sensor Proximity.
- Rear axle adjustments.
- Removing / Installing the front end.
Confirm the tire pressures are proper before starting the calibration procedure.
- Connect the diagnostic scan tool to the vehicle.
- Navigate to the ACC module "ECU view".
- Select the "Misc Functions" menu.
- Select the "ACC DASM Drive Calibration" procedure and then comply with the instructions provided on the diagnostic scan tool.
NOTE:
A Wi-Fi Mobile Hot Spot router is required for this procedure.