Park Assist Module

REMOVAL 

1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
2. Remove the trim from the right quarter inner panel to access the Park Assist Module (PAM), which is located to the rear of the C-pillar and above the right rear wheel housing. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .
3. Disconnect the body wire harness connectors from the PAM connector receptacles.

   Courtesy of CHRYSLER GROUP, LLC

   1 - PAM

   2 - Fasteners

   3 - Body Wire Harness Connectors

4. Remove the fasteners that secure the PAM to the right quarter inner panel.
5. Remove the PAM from the vehicle.

INSTALLATION 

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

• Tighten the fasteners securely.