Description And Operation: Description
| 1 - Back |
| 2 - Front |
The front of the Display Screen Module (DSM) allows for touchscreen input commands to the radio via a short Low Voltage Differential Signaling (LVDS) wire harness, which is routed from the radio to the DSM and retained by wire harness clips. The back of the DSM houses the wire harness connections necessary for Controller Area Network (CAN) communication, power and ground circuits in one 8-terminal connector and LVDS touchscreen input and output circuits in the 4-terminal connector.
The wiring information includes wiring diagrams, details of wire harness routing and retention, connector pin-out information and location views for the various wire harness connectors, splices and grounds. For proper wire repair, refer to: WIRE SPLICING and connector repair procedures, Refer to: REMOVAL and Refer to: INSTALLATION . Refer to the appropriate wiring information.
The DSM cannot be repaired. If the DSM is damaged or ineffective, it must be replaced. Refer to MODULE, DISPLAY SCREEN (DSM), REMOVAL AND INSTALLATION .