Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. With the scan tool, read LBSS DTCs and record on the repair order.
2. With the scan tool, erase DTCs.
3. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
4. With the scan tool, read LBSS DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to: TESTING FOR AN INTERMITTENT CONDITION .
PROXI CONFIGURE THE LBSS
1. With the scan tool, perform the Proxi Configuration Alignment routine.
2. With the scan tool, erase DTCs.
3. Cycle the ignition switch from off to on at least five times.
4. With the scan tool, read DTCs.
  Did the DTC return?
  
  Yes
  - Go To 3
  No
  - Test complete.
  - Perform the BODY VERIFICATION TEST. Refer to: BODY VERIFICATION TEST .
PROXI CONFIGURE THE BCM
1. With the scan tool, perform the Proxi Configuration Alignment routine.
2. With the scan tool, erase DTCs.
3. Cycle the ignition switch from off to on at least five times.
4. With the scan tool, read DTCs.
  Did the DTC return?
  
  Yes
  - Go To 4
  No
  - Test complete.
  - Perform the BODY VERIFICATION TEST. Refer to: BODY VERIFICATION TEST .
CHECK THE BCM HARDWARE AND SOFTWARE PART NUMBERS
1. With the scan tool, look at the BCM hardware and software part numbers and record on the repair order.
  Are the BCM hardware and software part numbers correct for the vehicle?
  
  Yes
  - Test complete.
  - Perform the BODY VERIFICATION TEST. Refer to: BODY VERIFICATION TEST .
  No
  - Replace the BCM in accordance with the service information. Refer to MODULE, BODY CONTROL (BCM), REMOVAL AND INSTALLATION .
  - Perform the BODY VERIFICATION TEST. Refer to: BODY VERIFICATION TEST .